High Altitude Brewing: While holding the brewer handle up, push down slowly on the K-Cup ® pod in the pod holder until the bottom of the K-Cup ® pod is punctured by the exit needle. Lower the handle completely to close the lid.
Lift the pod holder door and place a K-Cup ® pod in the K-Cup ® pod holder. If using a travel mug, remove the drip tray and place the mug on the drip tray base. Press the POWER button to turn the brewer back on. NOTE: After 5 minutes the brewer will go into Auto Off mode. The one-time setup process is now complete and you are ready to brew! The brew is complete when the brew indicator light is no longer illuminated. Press the brew button to start the cleansing brew. Press the 8 button - the brew indicator light will blink. Press the CARAFE button - the 4 brew size buttons will blink. Do not fill filter basket with coffee grounds. Place the carafe on the drip tray and fill the water reservoir to the MAX fill line. NOTE: Between brew cycles, the brewer may take about a minute to reheat. The brew indicator light will pulse slowly on and off while the brewer is heating, and the light will turn solid once the brew begins. The initial heating process will take about 4 minutes. The cleansing brew will begin once the brewer is heated. The 4 brew size buttons will blink, press the 8 button - the brew indicator light will blink.
NOTE: The clock must be set in order to use the Auto Brew functionality. Use the H/M buttons to set the clock, then press the blinking brew button to confirm the time. Refer to your Water Filter Starter Kit for instructions.įill the reservoir with fresh water to the MAX fill line, and replace water reservoir.
#KEURIG K DUO PLUS INSTALL#
If you have a Keurig ® Water Filter, install it now. Place a large mug (12oz minimum) on the drip tray. positioned to the right, left, or Place a large mug (12oz along the back of the brewer to minimum) on the drip tray. The water reservoir can be Plug brewer into an outlet. For replacement parts, please visit Before You Brew
0 kommentar(er)
